Automatic winding machine inspection is more important than maintenance!

The automatic winding machine makes a very subtle sound when winding. This is the normal sound of copper wire. When the magazine is running, the sound of the guide wheel can be heard. Occasionally there will be a deflated sound, but overall it sounds very comfortable. No noise. Experienced people can judge whether there is a problem by the sound of the coil machine.
If the screw is not tightened or needs to be installed in this area, but if the screw is not installed, the inertial impact force generated when driving the spool part will cause the part to loosen. Seriously, when the impact sound is heard, the machine must be stopped immediately for inspection. If the base is not heavy enough, or the floor is not tidy, there will be a shaking sound when the base is running; there will be a "pop" sound; there is a lack of lubricant in the bearing. As I walked around the bearing room, I heard a hissing noise. The bead on the bearing is broken, and you will hear a squeak when you drive. If the rotor parts are loose, such as the heavy screws on the cage rotor blades, or the rotor shaft, the coiler will make a knocking sound. Shaft bending and bearing wear can also cause vibration and uneven friction noise. The paint on the wires has worn out, and the two wires crossed and made a "sizzling" sound, but the wires were short-circuited. It is the electronic components that are seriously damaged.
Therefore, regular inspection and maintenance are more important.






